Utilisation In Zone 1 (Category 2 Equipment In Accordance With Atex 94/9/Ec) - Monti Bristle Blaster Manual De Instrucciones

Operating instructions
GB/US
After maintenance tasks, all safety features removed must be correctly re-fitted.
The safety features and their protective action must be checked by an expert prior to placing the tool in operation.
Removing, disengaging and / or bypassing safety features (covers, trim panels, starting lever, etc.) and/or safety
guards can cause injury or damage and are therefore strictly forbidden by the manufacturer!
The manufacturer provides a warranty for the Bristle Blaster
conditions.
Claims under the warranty will be void if:
- Damage is caused by improper operation,
- Repairs or modifications are made by unauthorised individuals,
- Accessories and spare parts are used that are not suitable for the Bristle Blaster
Malfunctions must be reported immediately on detection. The Bristle Blaster
correspondingly.
Defects are to be repaired without delay to minimise damage and to avoid degrading the safety of the tool. Claims
under the warranty will be rendered void if this instruction is not followed.
4. UTILISATION IN ZONE 1
(CATEGORY 2 EQUIPMENT IN ACCORDANCE WITH ATEX 94/9/EC)
®
The Bristle Blaster Pneumatic can be used for machining the following metals in zone 1: carbon steel, free-
cutting steel, manganese steel, nickel steel, chromium nickel steel, molybdenum steel, chromium steel, chromium
vanadium steel, silicon steel and chromium nickel austenitic steel (all rusting or free of rust independent of the
degree of rusting), stainless steel, tungsten, copper and aluminium. Usage of the device in zone 0 is not approved.
It is not allowed to machine the following materials in zones 1 or 2:
- Magnesium, zinc, lithium, boron, titanium, zirconium, thorium or uranium.
The usage of one and the same belt for different materials is not allowed.
14
®
Pneumatic in accordance with its general terms and
®
Pneumatic must be marked
®
Bristle Blaster Pneumatic
®
Pneumatic.