Publicidad
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any other
connection voids the warranty.
• Keep away from flammable objects.
• The e l e c t rical system, and the method of electrically connecting the fixture to it,
must be in accordance with the National Electric Code and local building codes.
• Disassembly of the fixture will void the warranty.
• Use only a 65 watt, PL type fluorescent bulb. Use of any other bulb will
damage the fixture and void the warranty.
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any other
connection voids the warranty.
• Keep away from flammable objects.
• The electrical system, and the method of electrically connecting the fixture to
it, must be in accordance with the National Electric Code and local building
codes.
• Disassembly of the fixture will void the warranty.
• Use only a 65 watt, PL type fluorescent bulb. Use of any other bulb will
damage the fixture and void the warranty.
WARNING: Deviation from the assembly instructions may result in a risk of fire
or electric shock.
SAVE THESE INSTRUCTIONS
Important: Read Before Using!
Remove cardboard insert that is protecting bulb before use.
Step 1: Loosen the knob (turn counter-clockwise) located
on the back and top of the fixture (C).
Step 2: The doorframe and lens assembly will swing down
allowing access to the bulb. Remove the card-
board insert.
Step 3: Replace the door frame and lens assembly and
secure it by tightening the knob that was loosened
in Step 1.
Assembling the fixture
Step 1: Slide the upper handle with foam grip into the tube on the U-brac ket
which is located on the bottom of the fixture housing.
Step 2: Align the threaded screw holes in the handle with the two holes in the
tube and secure with the two screws provided.
Step 3: Slide the end of the "S" stand, with the screw hole in it, into the
remaining open end of the tube on the U-bracket located on the bot-
tom of the fixture housing.
Step 4: Align the threaded screw hole in the stand with the slotted hole in the
tube and secure with the knob provided. NOTE: First, slip the plastic
spacer over the screw that extends from the knob, making sure that
the flat side of the spacer rests against the knob itself. The curved
side of the spacer will rest against the curvature of the stand as the
knob is tightened down.
Installing the bulb
Step 1: Loosen the knob (turn counter-clockwise) located on the back and top
of the fixture (C).
Step 2 The doorframe and lens assembly will swing down allowing access to the
bu l b. R e m ove the new fluorescent bulb from its pack a g e.
Step 3: Push one of the plastic bulb retainer clips open and carefully insert
the bulb under this retainer clip. Repeat the process on the opposite
side, then push the bulb into the bulb socket. (D) NOTE: Be careful
not to damage the bulb.
1 3
(C)
Publicidad
