Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance.
The water contains mineral substances, which can cause the accumulation of sediment
in the device and impact the heating efficiency and the steam jet. Sediments should be
cleaned and removed frequently
(once a week if used frequently).
The following forms are suggested for cleaning:
1: First, turn off the power switch and pull the plug so that the machine cools
completely.
2: Make sure that the appliance is completely cold.
Remove the appliance outdoors, since water will come out of the appliance.
Then open the drain plug on the bottom of the appliance.
Place a full water tank in the appliance, so that the water flushes the boiler and
removes the sediment. If the sediments are not cleaned completely, repeat the above
process until the boiler is cleaned.
3: If anything blocks steam output, do not use the appliance until the outlet is cleaned.
Blocking can increase the pressure inside the device.
Use small clamps or other suitable tools to eliminate the blockage.
Storage.
1. Close the entire telescopic pole and then remove the hose and set it aside.
2. Take the water tank, empty the remaining water and clean, then replace.
3. Open the drain plug on the bottom and let the remaining water come out.
4. Clean the joint of the hose with clean water and replace it.
5. Put the steam head on the hook.
6. Put the machine in a dry place.
Specifications.
- Voltage: 220-240V / 50-60Hz
- Power: 1800W
- Steam Pressure: 35g / min
- Maximum height of the extendable support : 134cm
- Minimum height of the support : 52cm
- Capacity of the Water Tank: 1.8L
- Length of the steam hose: 145cm
Publicidad
