Setting Up The Laser Projector; Default Settings - BlissLights Ark Manual Del Usuario

SETTING UP THE LASER PROJECTOR

Before operating your laser projector, please read the "Before you Begin" section and
1. Insert the USB power cord into a powered USB port or use the included wall adapter to
connect to an available electrical outlet.
2. Place the Ark on a flat solid surface and aim toward desired ceiling/wall.
3. Press the power button. The nebula and laser will gradually illuminate
and begin moving by default.
4. To adjust the illumination angle for walls, slide the unit down to the forward position.
5. To turn off the light, cycle through the power button modes until the unit turns off
completely. Remove the power plug from electrical outlet.
6. Use the following buttons to control lighting effects:
Button 1 (effects):
• Power on
• Pulse mode
• Laser only
• Cloud only
• Power off

DEFAULT SETTINGS

Once the laser projector is plugged in, it will enter the default mode where all effects are
on. Use the buttons to change the effect settings and brightness. This light has a built-in
timer that is designed to automatically shut off after 6 hours of operation.
"Notice" section of this user's guide.
Button 2 (rotation):
• Rotation off
• Rotation on
3
Button 3 (brightness):
• High
• Medium
• Low