Section 4: Maintenance; Maintenance Schedule; Lubrication; Rail Maintenance - Generac GC1000S Manual Del Propietário

Section 4: Maintenance

Maintenance Schedule

WARNING
Risk of injury. Do not operate or service this machine
if not fully alert. Fatigue can impair the ability to
service this equipment and could result in death or
serious injury.
WARNING
Personal Injury. Before performing any maintenance
or service on this unit, shut off the motor, unplug the
power cord and wait five minutes for the unit to cool.
Failure to do so could result in serious injury.
Procedure
Check general equipment condition
Perform rail maintenance
Check belt
Check the condition of the electrical cord
Grease rack
Clean motor exterior and cooling fins.

Lubrication

All bearings are sealed units and should have sufficient
lubricant to last the life of your machine with normal use.
Perform machine lubrication per the following instruc-
tions.

Rail Maintenance

See Figure 4-1. Between each use, remove any debris
caught on the rail (A) or ram (B) and applying a rust pre-
ventative to any bare metal areas on the top of the rail.
This will assure the smoothest return action of the ram.
Owner's Manual for 10 Ton Kinetic Splitter
(000215)
(000719)
Table 4-1. Regular Maintenance Checklist
Before Each Use
CAUTION
Personal injury. Wear appropriate personal protective
equipment at all times while operating and servicing
unit. Failure to do so could result in personal injury.
Every 5 Hours





A
Figure 4-1. Rail Maintenance
Maintenance
(000419)
Every 25 Hours

B
010951
13