Greasing The Rack; Adjusting And Replacing The Belt; Checking And Adjusting Belt Tension - Generac GC1000S Manual Del Propietário

Maintenance

Greasing the Rack

NOTE: Grease the rack every five hours.
1. See Figure 4-2. Use a screwdriver to remove the
11 guard screws, washers, and lock washers (A)
that secure the center guard (B).
2. Remove the guard screws, washers, and locknuts
that secure the flywheel and guard.
B
Figure 4-2. Greasing the Rack (1 of 3)
3. See Figure 4-3. Disconnect return spring (C) from
eye bolt (D).
D
C
Figure 4-3. Greasing the Rack (2 of 3)
4. See Figure 4-4. Pull the rack out and grease rack
teeth (E), top side of rack, and pinion (F).
F
E
Figure 4-4. Greasing the Rack (3 of 3)
5. Push the rack back in and reinstall the return
spring to the eye bolt when finishing greasing.
6. Reinstall the guards.
14

Adjusting and Replacing the Belt

Checking and Adjusting Belt Tension

1. See
2. Remove the guard screws, washers, and locknuts
A
010722
3. See
010723
4. Push on the top of the belt with about 10 pounds of
010734
Figure 4-5. Use a screwdriver to remove the
11 guard screws, washers, and lock washers (A)
that secure the center guard (B).
that secure the flywheel and guard.
B
Figure 4-5. Adjusting Belt Tension (1 of 3)
Figure 4-6. Place a straight edge (C) across
the top of belt (D).
Figure 4-6. Adjusting Belt Tension (2 of 3)
pressure. The belt should deflect approximately 1/2
in (1.27 cm) to 5/8 in (1.59 cm). If the distance is
not between 1/2 in (1.27 cm) to 5/8 in (1.59 cm),
adjust per the following directions.
Owner's Manual for 10 Ton Kinetic Splitter
A
010722
C
D
010735