Denver MCI-102 Instrucciones De Uso página 56

SYSTEM SET UP PROCEDURE
A. AS A "SHELF SYSTEM" (TABLE TOP USE)
- INCLUDED 1 PC STAND FOR THE MAIN UNIT.
FIXING THE BASE TO THE UNIT:
1. PLACE THE STAND UNDER
THE UNIT.
3. STOP WHEN THE INDICATOR MARK ON THE STAND IS ALIGNED WITH
THE LOCK SYMBOL ON THE REAR CABINET.
(TO RELEASE THE STAND FROM THE UNIT , SLIDE THE STAND DOWNWARDS
(OPPOSITE DIRECTION) UNTIL IT BECOMES RELEASED.
CLICK
2. SLIDE THE STAND UPWARD
(SEE DIAGRAM BELOW).
INDICATOR MARK
WHEN THE
INDICATOR MARK
ON THE STAND
IS ALIGNED
WITH THE LOCK
SYMBOL , THE
BASE IS
PROPERLY
IS PROPERLY
INSTALLED.
LOCK SYMBOL
E-13
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Electric and electronic equipment and included batteries contains
materials, components and substances that can be hazardous to your
health and the environment, if the waste material (discarded electric and
electronic equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked with the
crossed out trash can symbol, seen below. This symbol signifies that
electric and electronic equipment and batteries should not be disposed
of with other household waste, but should be disposed of separately.
As the end user it is important that you submit your used batteries to the
approriate and designated facility. In this manner you make sure that the
batteries are recycled in accordance with legislature and will not harm the
environment.
All cities have established collection points, where electric and electronic
equipment and batteries can either be submitted free of charge at
recycling stations and other collection sites, or be collected from the
households. Additional information is available at the technical
department of your city.
ALL RIGHTS RESERVED
COPYRIGHT DENVER ELECTRONICS A/S
WWW.DENVER-ELECTRONICS.COM
Imported by:
Inter Sales A/S
Stavneagervej 22
DK-8250 Egaa
Denmark
E-14