Publicidad
❹
Install pads to bases.
Attach each pad to each
base.
❻
Install the metal washer on
each bolt with the concave
side facing up.
Concave side up.
❽
Jostle and rotate Landing Pad
in all directions to ensure it is
snug, but also allows a small
amount of adjustment to
prepare for final alignment and
tightening in steps 9 through X.
Instruction #1036055A-3/9
Attach Landing Pads using your vehicles
specific hardware identified on page 2.
❺
BE SURE TO USE
THE CORRECT PADS
AND HARDWARE
TO AVOID VEHICLE
4X
❼
with washer through Landing Pad, and into the
DO NOT ALLOW EDGES
OF PAD TO CURL
UNDER!
4X
Adjust landing pad positions then tighten
❾
Align position of
Landing Pads to
allow SkyLine or
Control Towers to
(steps 5 through 8)
Place Landing Pad over each roof
pocket making sure arrows face away
from the middle of your vehicle.
DAMAGE!
Using the 5mm hex wrench, guide fastener
threaded mounting point in the roof.
them down. (steps 9 through 12)
Using your SkyLine or Control Tower
instruction as a reference, carefully
place a bar and towers assembly onto
the landing pads.
fully close.
4X
4X
4X
Publicidad
