Eldom alto PM850 Manual De Instrucciones página 14

Insert the tools (13, 14, 15, 16, 17, 18) into the adapter (13) in the socket - fig 3.
-
USE
Filling the tank
Make sure the appliance is disconnected from the mains and the switch (4) is set to "O".
-
- Unscrew the valve to the left and pull it out.
A measuring cup (9) of water with a maximum of 400 ml should be poured into the tank, through the funnel.
-
- Tap water can be used to fill the tank, however, in the case of hard water it is advisable that distilled water be
used.
- Insert the valve and turn it clockwise until it stops.
- The water can be poured out after the appliance has been turned off with the button (4), disconnected from
the power supply and has cooled down.
- Wait until the appliance has cooled down, then remove the valve and pour out the water.
-
WARNING
• Do not unscrew the valve, replenish the water or replace tools while the appliance is in use. Before
the start of the water replenishment or tool replacement the appliance should be turned off with
the button (4) and disconnected.
• Do not use the appliance without water - it is possible to overheat the appliance.
• Do not pour any cleanser, perfume oils or other chemicals into the tank as this could damage the
appliance and pose a threat when used.
OPERATION
Before using the mop, vacuum clean the surface.
Make sure that the appliance is disconnected from the mains and the switch (4) is set to "O".
-
- Mount the appropriate tool (see "INSTALLATION") - table 1.
- When cleaning carpets, it is recommended that the nozzle (11) be used - fig 4. Do not use the nozzle (11) to
clean smooth surfaces, as it may be damaged.
•
14 EN
a1
a2
fig.3
rys.4