NORAUTO 2274267 Manual De Instrucciones página 74

NOTE: In group II, III, the top tether is not used for installation. Storage the top tether gears
EN
fixed link to top tether gears fixed link area on the behind of the backrest.
SEAT COVER REMOVAL
1. Set headrest in the highest position.
2. Remove the 5-point harness.
3. Remove the cover from the backrest and base.
4. First, remove the cover from the base of the headrest, then remove the cover from
the headrest.
To reattach the cover, reverse the above steps.
CAUTION: Do not use child restraint without the cover.
CAUTION: Check that the harness straps are not twisted and that they are correctly
inserted into the slots of the cover's straps.
INSTALLATION WITH VEHICLE SEAT BELTS
• WARNING: If the child is not secured properly, the child could be ejected in a sudden stop
or crash, resulting in serious injury or death.
• WARNING: If in doubt about the installation, consult either the child restraint
manufacturer or the retailer.
GROUP I (9-18 KG)
1. Place child restraint forward-facing (in the direction of travel) in proper seating
location, flat on the vehicle seat bottom and touching vehicle seat-back.
2. Select a forward-facing position from 1 to 4.
3. Pull the shoulder belt section through belt guidance 2. Place the lap belt section in
the belt guidance 3.
4. Pull out safety belt from the back to the side, lap belt section respectively from the belt
guidance 3 of the base. One side of the shoulder belt through the backrest and the
belt guidance 3, another side along the upper inside.
5. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to
make sure it is not twisted.
6. By pressing your knee on the child seat, tighten the car belt as follows: pull on the
lower part of the shoulder seat belt section near the vehicle seat buckle to tighten the
lap belt section.
72
CLICK