NORAUTO 2274267 Manual De Instrucciones página 77

the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the
child restraint is not stable and is shaking, reinstall.
4. Select a position 1.
5. First, pull out the belt from the belt ALR. Shoulder belt through the same side of
guidance 1, lap belt through the same side of guidance 3, then pull the shoulder belt
and lap belt together through another side of guidance 3.
6. To fasten the seat belt across child: lap portion of the vehicle seat belt should rest
within both lower belt guides with buckle located on the outside of the child restraint.
7. Place shoulder portion into the upper belt guide on the headrest so that belt lays
properly across child: on the collar bone, interior (A) to the shoulder (B).
8. Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to
make sure it is not twisted.
9. Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth
and snug across child in all locations.
CAUTION: The shoulder seat belt section must run diagonally backward. You can adjust the
course of the belt with your vehicle's adjustable belt deflector on both sides.
A
B
CLICK
WARNING: Check that child restraint is securely installed before each use.
INSTALLATION WITH ISOFIX CONNECTOR, TOP TETHER AND SEAT BELT
1. Place child restraint forward-facing (in the direction of travel)
in proper seating location, flat on the vehicle seat bottom and
touching vehicle seat-back.
2. Press the ISOFIX button to pull out the two ISOFIX locking arms
from the base bottom.
that the indicator turns into a red colour, which means ISOFIX
attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the
surface and the backrest of the vehicle seat.
3. Align ISOFIX attachments to the metal anchorages at the
bottom of the car seat's backrest and push it until it clicks.
will hear an audible CLICK! Ensure both sides of the ISOFIX
locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the
child restraint is not stable and is shaking, reinstall.
4. Select a position from 1 to 4.
5. To use the top tether, remove it by loosening the strap and unclipping it from the
storage anchor.
NOTE: Some vehicles have a third ISOFIX attachment point for a top tether, behind the
rear seat to stop the child restraint tipping forward in an accident. Check whether you car is
CLICK
You will hear an audible CLICK! Ensure
CLICK
You
EN
75