Publicidad
Idiomas disponibles
Idiomas disponibles
•
Plug the appliance into an appropriate power supply. The heat level and fan speed of the appliance can be
controlled independently using the upper and lower switches, respectively.
•
The lower switch controls fan speed. When the switch is in the left position, the fan is turned off. Move the
lower switch to the center position for low fan speed, or the right position for high fan speed.
•
The upper switch controls heat level. When the switch is in the left position, the heat is turned off. Move the
upper switch to the center position for low heat, or the right position for high heat.
•
The blue "COOL SHOT" button may be used to set a hairstyle after blow-drying. Click once to engage the
Cool Shot feature and click again to disengage.
•
After use, make sure both switches are in the left (O) position before unplugging the appliance.
•
Do not pull the cord to unplug the appliance; grasp the plug firmly to remove it from the electrical outlet.
The appliance is equipped with a thermostat that may cut out if the temperature exceeds a preset level due to partially
blocked air inlets/outlet openings. In the event that the appliance stops during use, turn off all switches and allow the
appliance to cool down. The thermostat will automatically reset. During use, do not block the air inlet/outlet openings.
When using the appliance near water, the use of an electrical outlet protected by a circuit breaker is strongly recommended.
SAVE THESE INSTRUCTIONS
INSTRUCTIONS
7
Publicidad
