Publicidad
Idiomas disponibles
Idiomas disponibles
Grow-Flex
Feed System
TM
Installation:
1. Insert the Upper Boot into the bin collar opening and rotate to align with direction
Caution: Nylon Nuts should be tightened until they are "snug." Over tightening of
2. Attach the Transfer Plate to the Upper Boot using the hardware provided in the
3. Insert the Slide Gate into the Transfer Plate slot so that it is in its operating
4. Prior to assembling the unloader to transfer plate, the correct restrictor plate
Hog Slat Inc. Newton Grove, NC USA May 2014
that auger line will go. The Upper Boot must be inserted into collar as far as it
will go. Using the holes in the Collar or ring as a template; drill eight (8) 11/32"
(8.8mm) diameter holes in the Upper Boot rim. Attach the Upper Boot to the Bin
Collar using the hardware provided. See Figure 1 for correct orientation and
assembly of hardware. Hardware should be tightened evenly around the Bin
Collar to avoid uneven stresses applied to Upper Boot.
IMPORTANT: Failure to follow these instructions may cause breakage of
Upper boot.
nuts can crack nuts or lead to cracking of boot.
predrilled holes. (See Figure 1). Transfer Plate should be orientated so that the
Slide Gate slot is opposite the unloader outlet tube. Please note that screw
heads are located on the inside of the Transfer Plate, with nylon washer located
under the nuts. Again the tightening sequence should be evenly around the
Transfer Plate/Upper Boot to avoid uneven stresses on Upper Boot.
Note: It may be necessary to enlarge holes in either the Upper Boot or Transfer
Plate to insure proper alignment between the two; especially between different
OEM manufactures.
position before bolting the Slide Shield in place. Fasten the Slide Shield to the
Transfer Plate using two 5/16"-18 x 3/4" screws, washers and nuts to secure
Shield.
configuration (if any) should be assembled to the unloader for the specific
application with supplied 5/16-18 x ¾" Bolts and Nuts. Please see Figure 2 for a
guide.
Restrictor Baffles are supplied (unassembled) with GrowerSelect Unloader Kits
and are available for separate purchase from any Hog Slat Store or through Hog
Slat catalog sales.
PLEASE NOTE: It is up to the individual end user and installer to decide the
proper restrictor plate assembly and location base on individual
application and feed type. It is not recommended that the slide gate be
used to restrict feed flow. The following chart is a guide only.
3
Publicidad
