Characteristics Of The Pzd250 Programmer - Zemper PZD-250 Manual Del Usuario

Characteristics of the PZD 250 programmer:
The PZD 250 is a device that allows to check the status of the ZD+ luminaires, configured for RS485 communication
(check luminaires instructions), operate on them and programme them.
The programmer is composed of the following hardware elements:
1 zone for the control, programming, and checking of the luminaires. This zone has a capacity to check up to

125 luminaires. These ones must be numbered from 1 to 125 (see Numbering of Luminaires).
2 entrance connections, one is RJ4/4 type, and the other is power strip for cables of up to 2,5 mm.

Place for batteries type AA, closed by screws.

4 x 1,5V-AA batteries.

Green screen with resolution 34 x 64 mm, with incorporated light. This screen has an energy saving mode, so

if it remains 5 minutes, the programmer automatically goes off. The screen enables you to navigate around all
the options of the programmer.
A red LED for communication failures.

If the LED is on, this means that the last command sent to one a several luminaires has not been correctly

done.
A green LED indicating the device is on.

A green LED indicating communications with the luminaires. This led blinks when the programmer sends a

command.
A ON/OFF key. By pressing this key, you switch on the programmer, and by pressing more than 3 seconds,

you switch it off.
2 scroll buttons of screen menu. You can move through the different lines of the menu that appear on the

screen "up/down".
A key of command confirmation "OK". When you press this key you execute the highlighted and selected

option on the screen by using the scroll buttons.
A key to cancel commands "ANUL". By pressing on it, you leave the screen/menu you are executing.

10 numeric keys (from 0 to 9).

It also has the following software elements:
Language selection. The device allows to select the language of the information shown on the screen. (see

Change of Language).
The available languages are Spanish, English and French. If another additional language is required, please

contact Zemper (see contact details, technical service).
With this programmer, you can carry out the following operations:
Numbering the luminaires.

Switch-on/switch-off of the luminaires connected to it.

Reset of all the luminaires connected to it. Recognition of the luminaires installed in a zone. You can

memorize the luminaires recognised and the failures presented by each one.
Verification of the correct communication of the zone you are checking.

Verification of the establishment of communication with all the fixtures installed in a zone.

Switch-on, switch-off, reset of a determined luminaire of a zone.

Changing the number of a determined luminaire already installed.

The purpose of this programmer is to be a useful and necessary tool for the installation and verification of a

facility monitored by PC, so as to facilitate the installation and system maintenance.
26