PITT Front Side Instrucciones De Instalación página 6

Installation instructions Front Side
1. Overview of the various parts.
!
4. Turn all set screws back to approxi-
mately 3 mm above the unit. Then place
the heat conductor on the unit.
7. Place the heat shields including the
sealing ring (step 2) on the burners and
screw them with the supplied screws.
EN
!
Installation FS 2019 NL-EN-FR-DE-ES-IT EU PC 2 combi.indd 6
!
2. Carefully press the sealing ring over
the edge of the heat shield. Check
whether the ring fits well in its entirety.
5. Place the flanges in the designated
cutouts and position the unit carefully
under the worktop. Check that the heat
conductor is positioned correctly.
8. Always make sure that the V-shaped
indicator is in line with the shaft of the
burner housing of the wok burner. This
heat shield is attached with three screws.
Important!
When the control knobs are not properly adjusted the
burners will not ignite or burn evenly.
For warranty and the proper functioning of the cooking
unit ensure the mounting is as described in this manual to
the letter.
S
S
S
S
3. Overview of the set screws (S).
6. Check that the flanges are centered in
the cutouts. Note: if this is not the case,
the flanges will not function properly.
75 mm
9. Measure the distance between the
front of the unit and the front frame (or
blende). This distance must be 75mm.
S
S
!
4-4-2019 17:59:58