PITT Front Side Instrucciones De Instalación página 7

10. Note: the adhesive strip under the
sealing scale of the knob may not yet be
removed.
!
13. Correct centered gas taps.
13-15mm
16. Check whether the knobs stick out
sufficiently. The knobs should have a
distance of 13-15 mm above the sealing
scales.
!
19. Check that the heat conductor makes
full contact with the worktop.
Installation FS 2019 NL-EN-FR-DE-ES-IT EU PC 2 combi.indd 7
11. Slide the unit carefully into position
until the gas taps are vertically aligned
with the cutouts in the front frame (or
blende).
75 mm
14. Measure the distance between the
front of the unit and the front frame (or
blende) again. This distance must be 75
mm.
17. Check that the knobs turn smooth-
ly and return to the rest position after
pressing. If necessary, remove the sealing
scale and replace them again.
!
20. Support the unit with the double
PITT cooking support set. (see enclosed
®
installation instructions)
12. Tighten the set screws from the back
to the front until the gas taps are centered
with the cutouts. Check that all screws are
tightened.
15. Remove the adhesive strip from the
sealing scale. Press the knob and the
sealing scale as a one on the gas tap, so
that they are centered and aligned.
18. Connect the unit to gas and electricity
and ignite the burners. If the flames go
out after ignition, the knobs have to be
adjusted again (step 9).
21. The unit is now ready for use.
!
EN
4-4-2019 17:59:58