Installation Instructions - Utilitech Pro MPL1009-LED40K840 Manual Del Usuario

SAFETY INFORMATION
WARNING
Any changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
BE EXTREMELY CAREFUL WHEN USING THIS DEVICE. Improper use of this work light
can result in injury or death. Follow all safeguards stated in this manual in addition to
normal safety precautions in working with electrical devices. DO NOT attempt to service
this device.
-
When using outdoor portable work lights, always follow basic safety precautions to reduce
the risk of electric shock and personal injury.
- Failure to observe the following safety rules may result in FIRE, ELECTRICAL SHOCK,
INJURY, or EXPOSURE TO EXCESSIVE ULTRAVIOLET RADIATION.
-
Use only 3-wire UL Listed outdoor extension cords that have 3-prong grounded plugs and
grounded receptacles that accept the work light's plug.
-
Use only with an extension cord for outdoor use, such as with cord type SW, SW-A, SOW,
SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW, SJTW-A,
SJTOW, or SJTOW-A.
-
This product contains chemicals, including lead, known to the state of California to cause
birth defects and other reproductive harm. Wash hands after handling or touching this
portable work light.
-
To avoid electrical shock, do not use near water or in areas where water may accumulate.
Keep work light at least 16 ft. from pools or spas. Keep plugs dry. Use only Ground Fault
Circuit Interrupter (GFCI) protected receptacles when using this work light in wet or damp
locations. Receptacles are available with built-in GFCI protection and are to be used for
this measure of safety.
-
Always unplug work light and allow lamp head to cool.
-
The work light lamp heads get HOT very quickly. Only touch the power plug or cushioned
handle when turning the lamp heads ON or OFF.
-
To avoid burns, do not touch the glass lens or any metal part of the lamp head while lamp
is turned on.
-
Do not look directly at the lighted lamps to avoid eye injuries.
-
Always keep the work light away from any flammable materials.
- Unplug and allow lamp to completely cool.
-
Do not operate work light if it has a missing or damaged lens cover. Contact customer
service for a replacement. Read and follow all safety rules and operating instructions
before first use of this product.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 5 minutes.
Tools Required for Assembly (not included): Phillips screwdriver, Pliers.
Lowes.com
4

INSTALLATION INSTRUCTIONS

1. Pivot the Light Fixture (A) until Lens Assembly (C) is
angled down 45 degrees.
2. Secure the Light Fixture (A) to the Light Fixture Stand
(E) using two Screws (AA).
Hardware Used
Screw
AA
3. Insert Lock Pin (BB) through the center of the Light
Fixture Stand (E) and secure the Lock Pin (BB) by
using the Nut (CC) with pliers (not included).
Hardware Used
Lock Pin
BB
Nut
CC
1
A
2
A
AA
x 2
E
3
CC
x 1
x 1
E
BB
Lowes.com
5