Setting The Compressor Delay - Phcbi MDF-DU300H Manual De Instrucciones

SETTING THE COMPRESSOR DELAY

The delay time before the compressor starts can be changed to reduce the load on the power line and to
facilitate the start-up (reset) of the freezer during recovery after power failure.
 Setting range of delay time: between 3 and 15 minutes, in 1-minute intervals
 Initial setting (factory setting): 3 minutes
Note:
There is no need to change the delay time when the capacity of the power source is adequate.
For example, to change the setting of the compressor delay from 3 minutes (initial setting) to 4 minutes
(The following is only an example. Choose the setting according to the desired start delay.)
Operation
1
Press the up arrow key for 5
2
seconds.
3 Press the up arrow key 5 times.
4 Press the "Set" key once.
Press the up arrow key (as many
5 times as needed to reach the
desired figure).
6 Press the "Set" key once.
The unit will return from setting mode to temperature display mode automatically after 90 seconds if no
key is operated (auto-return function). In this case, the setting is not changed..
26
Key operated
The current chamber temperature is
----
displayed.
The current chamber temperature
changes to function code F00 and
the right-hand figure (0) blinks.
The display changes from F00 to F05.
The current setting (003) is displayed
SET
and the right-hand figure (3) blinks.
The display changes from 003 to 004.
The new setting is memorized and
SET the current chamber temperature is
displayed.
Display after operation