PRASTEL EASYBKA Manual De Instrucciones página 55

EASYBKA - EASYBKR
The factory default setting for the keypad heater is disabled, to changing
it:
1. Enter Programming Mode.
2. Press "6" to enter Menu 6: the Mode LED will flash green.
3. Construct the digit code 3 0 0 and the fourth digit as follows:
"0" to DISABLE the heater
"1" to ENABLE the heater
21. Replacing a lost Programming Code
NOTE: The EASYBKA/R must be in Normal Mode otherwise this will
not work. Make sure that the Mode LED is green before proceeding
1. Remove power
2. Press the REX button
3. Apply power to the unit with REX button pressed
4. Release the REX button
5. Within 15 seconds :

enter programming mode by pressing # twice

insert the default programming code (see table in paragraph 8)

Press 3 to access the programming code modification function

Enter the new programming code.
The EASYBKA/R returns to Normal mode: the 'Door' LED
6.
switches off and the 'Mode' LED turns green.
22. Replacing a lost Normal / Secure Code
NOTE: The EASYBKA/R must be in Secure Mode otherwise this will
not work. Make sure that the Mode LED is red before proceeding.
1. Remove power
2. Press the REX Button
3. Apply power to the unit with REX button pressed
4. Release the REX Button
ENGLISH
55
ISEASYBK_08_18.pdf.docx