Stocker Solarjet Alu Spotlight Manual De Instrucciones página 8

Introduction
Thank you for purchasing a quality unit. Used carefully and in accordance with the instructions set out below,
your SOLAR GARDEN LIGHT SYSTEM should give you many years of trouble free use. Please read the
instructions carefully to obtain the best results from your purchase.
Your unit features:
Solar powered by Big size high quality crystalline solar panel
•
New Zinc Alloy housing spotlight
•
No Mains Power
•
Simple wiring
•
Water proof design provides longer life in all weather conditions
•
Automatic sensor turns the light on at dusk
•
3 X Solar Rechargeable Ni-MH batteries (1000mA) included
•
1 X light with 5 meters wires, 9 pcs brighter super bright LED
•
The light can be put under cover and shade-anywhere as your want.
•
Location of the SOLAR CONTROLLER
1) For the best result, please locate the solar
controller in a position where it can get direct
sunlight on the solar panel, and generally free
from cover and shade. (As shown in figure 1).
2) Make sure that the photo sensor is not going to
be affected by any other light source. Otherwise the light will not illuminate at dusk.
3) The SOLAR CONTROLLER must be left to charge for 2 sunny days before best results are achieved.
Assembly Instructions
Solar controller installation
1) Carefully remove the UNIT and all the fittings out of the box.
2) Assemble the mounting poles (2), and stakes (3); Push the stake directly into the
ground (DO NOT hammer the light or the stakes) (as shown in figure 2).
3) Slot the controller head (1) on the upper part of the mounting poles carefully.
4) Adjust the switch under the solar panel to "AUTO" position.
5) Wall or roof mounted by screws (figure 3)
-
Instructions Manual –
2
3