Admiral AAV-3 Guía De Uso Y Cuidado página 9

In wash water temperatures below 60 ° F
Note:
(16° C), detergents do not dissolve well or clean
well. Care labels define cold water as up to 85 ° F
(29° C).
STEP 4
Select Options
EXTRA RINSE
When the knob is in the on position, an additional
rinse at the end of the COTTONS cycle is provided to
more completely remove laundry additives, suds,
perfumes, etc.
END OF CYCLE SIGNAL
The end of cycle signal will sound once the cycle is
completed. The end of cycle signal can be canceled by
setting the switch to Off.
STEP 5
Select Cycle
To select a cycle, push the control dial in (off position)
and turn it to the right (clockwise) until the pointer is at
the number of minutes desired for the wash load.
IMPORTANT: For optimum fabric care, the
appropriate wash and spin speed for the load type
must be selected using the WASH/SPIN SPEED knob.
(if desired)
(select models)
COTTONS Cycle
For regular fabrics, select the cycle time and turn the
Wash/Spin Speed dial to Normal/Normal.
For fabrics needing a slower spin speed to reduce
wrinkling, set the control dial on Wrinkle-Free and
turn the wash/spin speed dial to Normal/Slow.
DELICATES Cycle
This cycle provides up to 12 minutes of agitation.
Depending on the load, select either the Slow/Slow
or Slow/Normal wash/spin speed.
SOAK Cycle
This cycle provides approximately 30 minutes of
agitation and soaking to help remove stubborn dirt
and stains. For more information see page 10.
STEP 6
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial in. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Note:
Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
Control features vary by model.
8