Stainless Steel Surfaces; Light Bulbs - GE PV977 Manual Del Propietario Y Instalación

Surfaces
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the brush line. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser™ will remove surface rust,
tarnish, and small blemishes. To receive a coupon for
a trial sample of Bar Keepers Friend Soft Cleanser™
follow the link below or scan the QR Code.
barkeepersfriend.com/ge
Lights
CAUTION
Allow bulbs to cool before touching.
To change the light bulbs:
1. Remove the lamp lens cover by inserting a small flat
blade screwdriver into each of the three slots and
gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
2. Wear gloves. Do not touch the bulb with your bare
fingers. Skin oils can cause early lamp failure.
3. Grasp the bulb and pull it straight out.
4. Replace with the same wattage. Early bulb failure and
damage to or failure of the transformer may occur if
wattage
is too high.
These 12-volt, 20-watt halogen bulbs with a G4 base
are available at specialty lighting stores and home
building centers.
To order replacement bulb no. WB01X10239, contact
the GE National Parts Center at 1.800.626.2002 or
purchase from your local retailer.
5. Replace lamp lens cover by inserting
the three retaining tabs into the three slots and
pressing firmly in place.
49-2000833 Rev. 0
Use only a liquid cleanser free of grit and rub in the
direction of the brush lines with a damp soft sponge.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, please visit geappliances.com/parts
Use a small flat blade screwdriver
to remove the lamp lens cover.
Tab
NOTE: Make sure the tabs are inserted into the slots.
Bulb
Outer trim ring
(lamp assembly)
Do not remove
Removable inner
lamp lens cover
7