Sauder 412321 Manual Del Usuario página 17

13 13
FF
F
OO
NAIL
(29 used in this step)
Carefully turn your unit over onto its front edges. Lay the BACK (G) over your unit.
Make equal margins along all the short edges and long edges of the BACK (G). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACK (G) to your unit using the NAILS (OO).
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (E).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
Tighten the TWIST-LOCK ®
Push two CORD CLIPS (FF) into the holes in the SMALL BACK (F).
412321
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
FASTENER in the SMALL BACK (F).
www.sauder.com/services
These holes must line up
over the SHELF (E).
G
Page 17