Tips To Help You Save Energy; Troubleshooting - Bosch Sensixx DS37 i-Temp Advanced Instrucciones De Uso

advice on disposal
our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the
local waste disposal service as secondary raw
materials. your local town council can give you
information about how to dispose of obsolete
appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment - WEEE).
The guideline determines the framework for
the return and recycling of used appliances
as applicable throughout the EU.
Trouble shooting
problem
pilot light (6) flashes. • Boiler must be rinsed.
The steam generator
does not come on.
The iron does not
heat up.
The iron begins
to smoke when
switched on.
Water flows through
the holes on the
soleplate.
possible causes
• There is a connection problem.
• The main power button is not
switched on.
• The main power button is not
switched on.
• The temperature is set to a low
position.
• During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
• The steam function is being
used before it has reached the
correct temperature.
• The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
Tips to help you save
energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
▪
Start by ironing the fabrics that require the
lowest ironing temperature.
▪
Check the recommended ironing temperature
on the label on the garment.
▪
regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
▪
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
if you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
▪
if the fabrics are damp enough, turn off the
steam regulator completely.
Solution
• rinse the boiler according to the cleaning
instructions in this manual.
• Check the mains cable (9), the plug and
the socket.
• Set the main power button (7) to the "i"
position (illuminated in red).
• Set the main power button (7) to the "i"
position (illuminated in red).
• Set the temperature to the desired
position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• reduce the steam flow when ironing at
low temperatures.
• point the iron away from the ironing area
and press the steam release button until
steam is produced.
19
BOS CH