Ironing Without Steam; "Sensorsecure" Function; After Ironing; Tips To Help You Save Energy - Bosch Sensixx'x DA50 SensorSecure Instrucciones De Uso

3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button (2) repeatedly with pauses of
at least 5 seconds.

6. Ironing without steam


See the leaflet sides
This enables the iron to be used for dry
ironing.
Set steam regulator (3) to the
7. Drip protection *
DripStop

See the leaflet sides
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
8. Spray

See the leaflet sides
This can be used to remove stubborn
wrinkles.
Do not use the spray function with silk.

9. "SensorSecure" function


See the leaflet sides
The "SensorSecure" function makes the iron
heat up only when the handle is gripped, and
stop heating when the handle is no longer
gripped. Thus, safety and saving energy get
increased.
1. Plug in the iron.
2. "SensorSecure" light (15) flashes when
the handle is not gripped, and will show a
continuous light when the handle is gripped.
3. If the iron handle is released for more
than 10 seconds, the iron will stop heating
automatically.
4. When the handle is gripped again, the iron will
start heating up again.
Initial heating up process: it is not necessary
to grip the handle until the iron heats up to the
set temperature. Once reached such
temperature, the pilot light (13) goes off.
* Model dependent

1. Switch the steam regulator (3) from
and back again several times (self- cleaning).
2. Empty the tank. Hold the iron with the point
down and shake lightly.
3. Store standing on the rear, not on the base.
4. Do not wrap the power cord (14) too tight!
position.
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
3 Only use steam if necessary. If possible, use
the spray function instead.
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
program.
4. If the fabrics are damp enough, turn off the
steam regulator (3) completely.
5. Stand the iron upright during pauses. Resting
it horizontally with the steam regulator on
generates wasted steam.

E
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (7) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.

10. after ironing

See the leaflet sides

Tips to help you save energy

Cleaning & maintenance
See the leaflet sides
attention! risk of burns!
always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
to "max"
15
BOS CH