Operation; Maintenance And Care; Cleaning And Maintenance - Klarstein 10028493 Manual Del Usuario

Start operation
1. Ensure that the unit is connected to the power socket.
2. Make sure the water tank is placed in proper position. (After plug on the machine for the first time, if the
full tank lamp light up, just pull out the water tank then push it back to the proper position.)
3. Press the power control to turn on the machine. Press
4. If the humidity indoor is over the set humidity, then the machine will start removing moisture.
5. When the humidity in the room reached the set humidity then the machine will stop operating.
6. When the humidity in the room is over the set humidity then the machine will start removing moisture
again.
For safety reasons, make sure the dehumidifier is unplugged before serving or cleaning the machine.
Cleaning the shell
1. Wipe the shell with a clean, soft cloth.
2. If the dehumidifier is very dirty, use mild detergent then wipe off the detergent with half dried cloth.
3. Do not wash the machine with a hose or immerse it in water. This may cause leakage of electricity.
Cleaning the air filter
The purpose of the air filter is to filter dust and other materials from the air. If the filter is blocked by dust the
electricity usage will be greater than normal, For optimal moisture removal efficiency, clean the filter every
two weeks.
Cleaning Steps
1. Remove the water bucket and tip the appliance towards the rear at an angle of approximately 15 degrees.
The filter is located behind the front grill and should be pulled downwards to remove.
2. Clean the filter with a vacuum cleaner or wash it with clean water and dry with a dry cloth.
3. Put the clean air filter back in place and water bucket. continue to operate the dehumidifier
Emptying the water bucket
When the water tank is full, the indication lamp will light up, the dehumidifier will stop operating.
Remove the water in the tank, then place the water tank back to it's proper position the machine will
start operating again.
Note: Remove the water in the water tank with two hands.

Operation

Cleaning and Maintenance

to select humidity setting.
12