Porter Cable PCE341 Manual De Instrucciones página 5

Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contains chemicals known to the State of California
to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area,
and work with approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
Use of this tool can generate and/or disburse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/
OSHA approved respiratory protection appropriate for the dust exposure.
Direct particles away from face and body.
Always wear proper personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use,
noise from this product may contribute to hearing loss.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ............... volts
Hz ............. hertz
min ........... minutes
........ direct current
............. Class I Construction
................. ................. (grounded)
............. Class II Construction)
................. (double insulated)
.../min ...... per minute
IPM........... impacts per minute
sfpm ......... surface feet per minute
SPM ......... strokes per minute
SAVE THESE INSTRUCTIONS
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC means
your tool will operate on alternating current. As little as 10% lower voltage can
cause loss of power and can result in overheating. All PORTER-CABLE tools are
factory-tested; if this tool does not operate, check the power supply.
A .......... amperes
W ......... watts
....... alternating current
....... alternating or direct
............ current
n o ........ no load speed
......... earthing terminal
......... safety alert symbol
BPM .... beats per minute
RPM .... revolutions per
............ minute
5 - ENG