Technical Data - Forch 5352 2200 Manual De Instrucciones

■
Do not use device in hazardous areas. Tools as grinders/cutters could cause sparking
which can lead to ignition of flammable materials. Never operate tools near flammable
substances such as gasoline, naphtha or cleaning solvents etc.. Only work in clean,
well-ventilated areas where there are no flammable materials. Never use oxygen, carbon
dioxide or other bottled gases to power pneumatic tools.
■ Do not aim at other persons. When operating the tool keep children and other persons
out of the working area.
■ Do not use device at idle.
■ Pneumatic tools must not get in contact with power sources.
■ Pay attention to operating pressure, max. air pressure – see table page 8.
■ Exceeding the permissible maximum pressure of tools and accessories could cause ex-
plosions and lead to severe injuries. The maximum pressure of the compressed air must
be equal to or slightly below the allowable pressure load of the grinder/cutter.
■
Check hose connections for tight fit. Do not use defective compressed air hoses. Twirling
compressed air hoses can cause severe injuries.
■
Disconnect pneumatic tools only in unpressurized state. Twirling compressed air hoses
can cause severe injuries.
■
Only use dry, clean compressed air. Never use oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
■
Only use spare parts, fittings and accessories recommended by the manufacturer.
■
Never carry the device at the compressed air hose.
■
Never carry the tool connected to compressed air with your finger on the actuating lever.
■
Avoid unintentional operation.
■
Keep handles always dry, clean, oil- and grease-free.
■
Make sure to have a clean, well-ventilated and always well lit working area.
■
Never use the tool under the influence of drugs or alcohol.
■
Repairs must be executed by authorised personnel only.
■
Marking of the device has to be always easily legible. It's the operator's responsibility to
keep the label with warning instructions, turns, serial and article number undamaged and
in well legible state.
■
Never use quick-coupling systems directly at the device. There has to be at least
a 20 cm hose separating the quick-coupling system from the unit.
■ Always change cutting disks only when the compressed air hose is disconnected.
■ Pay attention to the safety instructions.
■ Only use the cutting / grinding disks specific for this special tool.

10. Technical data

Air connection thread:
Grinding /cutting disk:
Max. idling speed:
Power:
Weight:
Recommended hose diameter:
Air consumption:
Operational pressure:
Sound power level:
Vibration acceleration:
Dimensions of the device:
1⁄4"
50 × 6 mm
23.000 U/min
224 watts
0,5 kg
10 mm
113 l/min
6.3 bar
81 dB(A)
6.5 m/s2
131 × 63 mm