Battery Maintenance; Battery Disposal - Husqvarna ROYAL 153 S Manual De Instrucciones

U U U U U
MAINTENANCE
(starts at page 51)
lFor a four stroke engine, check the oil level and change the oil when dirty. For further
explanation, see ENGINE INSTRUCTION BOOK.
lFrequently check the mower and ensure that all grass deposits are removed from
beneath the deck.
lNever clean the mower by pouring water over it: this may seriously damage the electric
start system.
lTake care, the exhaust muffler may be very hot.
lFrequently remove the wheel screws clean whith petroleum and oil before replacing.
Ball bearings must be greased before remounting.
BLADE
(starts at page 51)
V V V V V
W W W W W
Y Y Y Y Y
KIT ELECTRIC STARTING
l Before starting the motor for the first time, you are advised to keep the battery on charge for 2 to 3 hours.
If the battery proves to be low during starting, charge it for 24 hours.
When starting, don't keep trying to start for more than 5 seconds.

BATTERY MAINTENANCE

IMPORTANT
For correct battery maintenance (34), especially in preparation for a long period of inactivity, and for recharging, it is not necessary to remove it from its casing, but to simply proceed
as follows:
1) Remove contact (35).
2) Store the battery in a fresh and dry place.
3) Recharge the battery before use at room temperature for 24-36 hours.
4) Restore the contact (35) before use.

BATTERY DISPOSAL

Those batteries marked with a "crossed out waste disposal bin" and bearing the chemical symbol Pb (battery containing lead) are not to be disposed in domestic
waste bins.
Pb
The user is legally obliged to take the used batteries to special collection points or to return them to the retailer.
Pb
Caution! Switch off the motor and disconnect the spark plug before undertaking any
maintenance work.
lTo remove the blade (26) unscrew the screw (27).
lCheck the conditions of the blade-support (28), the washer (29), the key (30) and the washer (31) and replace any parts which are damaged.
lWhen reassembling, make sure that the key (30) is correctly seated in the shaft and that the cutting edges face in the direction of the engine
rotation. The blade screw (27) must be torqued to 5,34 Kgm (52,4 Nm).
lTo remove the blade (32) unscrew the two screws (33).
lCheck the condition of the blade and replace any parts that are damaged, re-assemble using two screws (33) which must be torqued to 5,34
Kgm (52,4Nm).
(starts at page 52)
lFrequently check the blade for damage.
lThe lawn mower must be checked by a SERVICE DEALER.
lCleaning under the bodywork
With machine at a standstill and off.
- Attach fitting (25) on the deck to the water supply tap. Turn on the tap.
- start up the motor (blade in rotation), allowing it to warm up for a few minutes.
- at the end of cleaning switch off the motor, turn off the tap, detach the tube from the
deck connection.
11
ENGLAND