Maxon 297115-01 Instrucciones página 6

Always route electrical wires clear of moving parts, brake lines, sharp
edges and exhaust systems. Avoid making sharp bends in wiring. Attach
securely. If drilling is necessary, fi rst check behind the drilling surface so
you do not damage fuel lines, vent lines, brake lines or wires.
4. Insert control switch wiring into
the 3/4" hole on the corner
post and run it down, out and
under the vehicle body to the
pump assembly. (See dashed
line - FIG. 6-1.) Secure wiring
to vehicle body using frame
clips and/or loom clamps with
self tapping screws (Kit items).
Then, attach switch in correct
position on corner post.
© MAXON Lift Corp. 2018
LIFT CORPORATION Sht. 6 of 18 DSG#
CAUTION
!
M-16-08
SELF-TAPPING
CONTROL SWITCH
CONTROL SWITCH
CONTROL SWITCH WIRING
FIG. 6-1
Rev. A Date: 07/02/18
SCREW
3/4" HOLE
WIRING
PUMP
ASSEMBLY