Beper P202VAL100 Manual De Instrucciones página 6

Electrolytic disinfectant maker Use instructions
Description of product Fig.A
1. Sprayer
2. Water tank
3. Base
4. ON/OFF switch
5. USB port
6. USB cable
7. Measuring spoon
Use warnings
Immediately unplug the appliance from the socket in case of any alleged malfunctioning.
Do not use or handle cable with wet hands.
Once the appliance is turned on, do not touch the water inside the tank.
Keep the solution obtained away from light, out of the reach of children, and use it within 24 hours.
Rinse the inside of the water tank thoroughly after each use.
If not used for long periods of time, keep the inside of the water tank clean and dry.
Warning:
Do not drink the solution obtained.
Do not inhale nor spray the solution directly on eyes, nose and/or mouth of humans or animals.
Note: the solution obtained has bleaching effect, pay attention when using on colored or dark textile
surfaces; do not use on silk and leather.
Warning: electrolysis produces high pressure gases, make sure to leave the sprayer nozzle open
during operation.
Important: strictly follow the quantities of water and salt indicated on the box and in this manual, to
avoid damaging the appliance and give rise to potentially dangerous reactions.
Instructions for use
Remove the sprayer, and proceed by pouring 200 ml of water and 6-10 g of salt (1 full measuring spoon) into
the water tank.
Tighten the sprayer making sure that it is securely fastened to the water tank, open the nozzle by turning it
counter clock wise, and connect the appliance to the power mains (with USB adapter – not included, or using
other sources of power, such as laptops, power banks, etc.) by using the USB cable provided with the appliance.
Press the ON/OFF switch; the LED light inside the water tank turns on, indicating that the electrolysis process
has started. After 5 minutes, the LED light and the appliance automatically shut off; the appliance enters stand-by
mode, and the disinfectant solution is ready to use.
Unplug the appliance from the socket, close the nozzle by turning it clockwise (to avoid accidental spilling of
liquid), and remove USB cable.
At this point, open the nozzle and direct the jet on the surface to be treated.
The solution obtained is a sodium hypochlorite-based disinfectant, which can be used for disinfection of dome-
stic environments, for removal of stubborn stains and bacteria.
It is recommended to spray a sufficient quantity of solution on the surface to be treated, and leave for at least 5
minutes; rinse thoroughly with water.
Technical data
Power: 10W
5V DC USB
For any improvement reason, Beper will reserve the right to modify or improve this appliance without
6