General Cleaning - Guardian Technologies pureguardian H1250 Serie Instrucciones De Uso Y Cuidado

DIRECTIONS FOR USE
3. Auto Humidistat
Press the Auto button to activate the automatic humidity function, then the ideal humidity of
50% is maintained. When the humidity level in the room is less than the auto humidity level
(50%), the humidifier will continue to produce moisture automatically. Once the room level is
met, the humidifier will turn itself off.
"Auto" LED is displayed when in use.
4. Adjustable Humidistat
Set the desired humidity in % by pressing the Adjustable Humidistat button. We recommend a
relative humidity of between 40% and 50%. The appliance can be regulated from 40% to 75%
in 5% increments. If the humidity exceeds the desired setting, the appliance will turn itself off.
The appliance will not turn itself off if it has been set for Continuous Operation ("CO"). The
desired value is shown while you are making the selection. After a few seconds, the display
automatically switches to the current value. Note: If the room humidity is below 15% then the
display will flash.
5. Timer
Press the Timer button to determine the operating time, it can be regulated between 1 and 12
hours or for continuous operation.
"Timer" LED is displayed when in use.
6. Low/No Water
When it is time to refill, the low water indicator will blink on the display.
7. Auto Shut Off
The unit will automatically shut off when the water level is too low. If this happens, unplug the
unit, remove the tank and refill.
E-8
CLEANING
CLEANING
• Always unplug the unit before servicing in any way.

GENERAL CLEANING

• Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh
water using the cleaning brush and a soft cloth as needed. Do not submerse the base of the
unit into water, or allow water to enter inside the dry air exhaust port of the unit.
• Water tank. Empty water tank. Pull and remove mist spout out of the tank. Clean the mist tube
with fresh water and a light brush (bottle cleaning brush is recommended). Return mist spout
after cleaning.
• Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If
you notice an accumulation of water during usage, reduce humidity and dry outer surface with
a cloth.
Tank
Power
Plug
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hardwater area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
Mist Spout
Mist Diffuser
Mist Tube
Base
Control Panel
E-9