STA-RITE Calypso GW7000 Manual De Instalación, Operación Y Repuestos página 5

Step 4: Connect the hose sections (Figures 9 and 10).
For best results and to retain your warranty, use only gen-
uine Calypso hoses.
Join the Calypso hose sections one to another by fitting the
male end to the female end of the added section (see
Figure 7). Make sure the connections are snug. The num-
ber of lengths that you will need depends on the size of
your pool.
Figure 7
The overall length of hose needed will be the distance
from:
(a) the point at which you will attach the hose to the suc-
tion connection, to (b) the furthest point in the pool from
(a), plus one hose length (Figure 8).
a
Figure 8
Submerge the hose so it fills with water and expels air from
the hose. Attach one ond of the hose to the vacuum source
as descrbed in Steps 2 and 3. Keep the other end of the
hose accessible.
Step 5: Adjust flow
1. Insert the flow gauge into the open end of the hose,
still underwater.
2. Start the pump.
3. Turn the adjustment knob on the flow regulator until
Figure 9 - Flow Indicated on Flow Gauge.
4. Turn off the pump.
5. Remove the flow gauge and attache the hose to the
Step 6: Attach the female end of the hose to the
Calypso (see Figure 10).
b
Figure 10
5
the indicator on the flow gauge is between the maxi-
mum and minimum flow (See Figure 9).
NOTE: If you have a very strong pump and the flow is
still too fast, slightly open the main drain.
cleaner.
Disc Indicator