Using The Appliance; Adjusting Suction Power - Philips Marathon FC9239/01 Manual De Instrucciones

English
8
Crevice tool, small nozzle and small brush
1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) directly to the
handgrip or to the tube (Fig. 10).
accessory holder
1 Snap the accessory holder onto the handgrip (Fig. 11).
2 Snap two accessories into the accessory holder:
- Crevice tool and small nozzle (Fig. 12).
Note: Make sure the suction opening of the small nozzle points away from the holder.
- Crevice tool and small brush (Fig. 13).
Note: Make sure the suction opening of the small brush points towards the holder.
Infrared remote control (specific types only)
1 Remove the lid of the battery compartment (1) and insert two AAA 1.5-volt batteries (2).
Reattach the lid of the battery compartment (3). (Fig. 14)
Make sure that the - and + poles point in the right direction.

using the appliance

1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Press the on/off button on top of the appliance to switch on the appliance (Fig. 15).

adjusting suction power

During vacuum cleaning, you can adjust the suction power to one of 5 different settings.
- You can adjust the suction power with the MIN and MAX buttons (specific types only) on top
of the appliance (Fig. 16).
- If the appliance is equipped with an infrared remote control (specific types only), you can adjust
the suction power with the – and + buttons on the infrared remote control (Fig. 17).
1 When you switch on the appliance, it starts running at the last selected suction power
setting. If your appliance is equipped with an infrared remote control (specific types only), it
starts running at the highest suction power setting (Fig. 15).
2 Adjust the suction power with the buttons on top of the appliance (specific types only) or on
the remote control (specific types only) (Fig. 17).
- Use maximum suction power to vacuum very dirty carpets and hard floors.
- Use minimum suction power to vacuum curtains, table carpets, etc.
The blue suction power lights show the selected suction power level.
,
pausing during use
1 If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to
park the tube in a convenient position (Fig. 18).
2 If the appliance is equipped with an infrared remote control (specific types only), press the
standby button to switch off the vacuum cleaner temporarily, for instance when you have to
move some furniture (Fig. 19).
The middle suction power light goes on to indicate that the vacuum cleaner is in standby
,
mode.
3 To continue vacuum cleaning, simply press the standby button, - button or + button.
4222.003.3333.2.indd 8 22-11-2007 10:31:58