Mounting Bracket Clamping Pressure; Collapse Stand Installation - ShopMaster DELTA S36-269 Manual De Instrucciones

MOUNTING BRACKET CLAMPING PRESSURE

Make sure mounting bracket clamping
pressure is sufficient to securely clamp
mounting bracket to the stand and lock clamping knobs
in place before each use.
5. It may become necessary to adjust mounting
bracket(s) if they do not hold tight to the rails on the
miter saw stand.
• Remove the mounting bracket(s) from the miter
saw stand.
• To adjust the mounting bracket(s), loosen jam nut
with 10mm open end wrench, with Phillips screw
driver turn screw to the right to adjust mounting
bracket clamp tighter or turn to the left to loosen
clamp.
• Re-tighten jam nut and reattach mounting
bracket(s) to the miter saw stand, and turn the
lock knob on the mounting brackets to the lock
position. Verify the mounting bracket(s) are
holding tight to the rails.
COLLAPSE STAND
1. Remove saw from stand
2. Fold legs in on stand by pushing spring pin in to
unlock legs from extended position as shown in
Figure 12 & 12a.
NOTE: If needed, have another person assist with
supporting stand while collapsing legs.
ADJUSTMENT INSTRUCTIONS
COLLAPSE STAND INSTRUCTIONS
11
FIGURE 11
FIGURE 12
a
SPRING
PIN