Using The Audio/Video Input Jacks; Using The Audio Output Jacks - Fisher PC-25S00 Manual Del Propietário

USING THE AUDIO / VIDEO INPUT JACKS
CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables.
1. Connect VCR or other equipment's Audio Out (R/L) to the TV Audio Input (R/L)
For Mono VCR (Single Audio Jack) only connect VCR Audio (L) Out to TV
Audio (L) In.
2. Connect VCR or other equipment's Video Out to the TV Video In
3. Press POWER to turn on the TV. See
4. Press the VIDEO MODE key
from the equipment you have connected to the A/V jacks. See
.
control operation
Back View of VCR
A/V JACKS
IN
RF
R- AUDIO -L
CHANNEL
CH3 CH4
OUT
R- AUDIO -L

USING THE AUDIO OUTPUT JACKS

CONNECTING A STEREO AMPLIFIER TO AUDIO OUT JACKS
1. Connect the TV Audio Out (R/L)
2. Press POWER on remote control (see
equipment also.
UHF/VHF/CATV
75Ω
Back of
AUDIO VIDEO INPUT
TV
R AUDIO
.
Turn on external equipment also.
to select program source: TV signal or signal
VIDEO
VIDEO
TV A/V Input
Rear Jacks
UHF/VHF/CATV
75Ω
AUDIO
AUDIO VIDEO INPUT
OUTPUT
VIDEO
R AUDIO L
(MONO)
to the Stereo Amplifier In (R/L)
above) to turn on the TV. Turn on external
AUDIO
OUTPUT
L
L VIDEO
(MONO)
R
.
and page 6 for remote
Remote Control
VIDEO
POWER
MODE RESET
1 2 3
4 5 6
L
R
.
Stereo Amplifier
QuickTips
.
Make sure all cable
connectors are fully
seated on jacks.
Always match cables
according to the
colors;
RED
audio,
WHITE
audio and
for video.
A solid Blue screen
with the words
Video displayed
means that the Video
mode is selected, but
no signal is being
detected at the Video
jack.
Position your TV at
least 2 feet from
stereo speakers.
The magnets in the
speakers may affect
the picture quality.
However, all Fisher
STV model speakers
are stray field com-
pensated and may
be placed next to TV
sets without any
special precautions.
D connect
O NOT
external speakers
directly to the TV.
for right
for left
YELLOW
9