SPORTSTECH HTX500 Manual De Instrucciones página 28

Step 7:
Now connect this protective net holder to the
basic structure so that the long end follows at
the top and is curved towards the center of the
Figure 10
trampoline. To fix it, use two screws (M6 * 7) from
the outside through the openings provided at the
lower end of the protective net holder and equip
them with one on the other side of the pipe rubber
nut (fig.10). Now place this on the outside of the
respective stand (#A1), guide the screws through
the openings provided for this purpose (Fig.10)
and secure on the other side with a nut each using
a washer and tighten in a clockwise direction.
Figure 11
Repeat this step a total of six times.
Step 8:
To increase your security, bring one of the black
protective caps in a further step on the long
screws that have just been fixed by turning them
clockwise to tighten (Fig.12).
Figure 12
Step 9:
Once all of the protective net holders have been
attached, pull them over the black protective
covers (#B5) from above (Fig. 13).
Note: The side with the slightly closed opening
should be facing up.
Figure 13
28