SPORTSTECH HTX500 Manual De Instrucciones página 31

Step 15:
Figure 24
Connect the two ladder poles (#F1) by bringing them
together at the bottom. Then slide the two steps (#F2)
onto the assembled ladder frame. Make sure that the
top of the stairs is facing upwards and that the small ho-
les on both sides of the stairs are on the side where the
ladder bars have 3 holes each (Figure 24). Fix the steps
at the level of the bottom four holes and turn the ladder
over. Now insert 2 nuts on the left and right into the
slots provided on the stairs and tighten them from the
other side with 4 medium-length screws in a clockwise
direction.
Step 16:
Once the steps are in place, attach the two ladder
Figure 25
Figure 26
hooks (#F3) to the top ends of the ladder rods
(#F1) and screw them clockwise with an M6 * 10
screw each (Fig.25).
Then use the ladder hooks to mount the ladder on
the basic structure of the trampoline at the point
EN
of entry and exit. To do this, simply lift the edge
cover, hook the ladder in the desired position and
then place the edge cover over it again so that the
entrance looks like in Fig. 26.
Step 17:
Now attach the sprinkler (#G) together with the hose to the
Figure 27
upper frame of the protective net (#D1). To do this, first
let the DIN-standardized water connection hang out of the
trampoline at the desired point and tighten it loosely with
one of the cable ties provided (Fig. 27). Then attach the
sprinkler hose clockwise in a similar fashion. Use the free
space on the connecting pieces of the fiberglass rods to
attach the cable tie.
Important: The sprinkler hose is attached twice around the
trampoline. It is recommended that you tighten the cable
tie loosely before running the water and carefully tightening
the cable tie so that the water can circulate freely. A long
garden hose for water supply is not included in the set and
must be purchased separately.
31