AOSmith AO-US-RO-4000 Manual Del Propietário página 7

INSTALLATION GUIDE
4
STEP 2 Install System Manifold
1. Select a space under sink that is at least
6" from bottom of your cabinet to allow
for filter replacements. Use mounting
holes located on back of system manifold
(A) to mark wall screw placements.
Ensure holes are level.
STEP 3 Install RO Faucet
You will need the faucet (F) and gasket, nut, washer and escutcheon (G) to complete this step.
Note: Sink top hole must be 1
body will mount flat against the surface and there is sufficient tubing between faucet and
system manifold.
1. Slide metal escutcheon
(G1) onto faucet base (F)
first and then black gasket
(G2). Feed tubing and
faucet threads through
countertop hole.
NEED HELP? GIVE US A CALL 877.333.7108
2. Use a
3. Mark screw placement of remineralizer
⁄ " diameter for the faucet. If drilling a new hole, ensure faucet
1
4
HOT
2. Thread metal washer
(G3) onto faucet threads
and then faucet nut
(G4). Tighten faucet
nut by hand.
⁄ " drill bit to drill pilot holes.
1
8
Mount unit to wall using two screws (U)
leaving approximately
exposed. Mount system manifold on wall
and screw into place.
holder 2" away from right side of
system. Using third screw (U), mount
remineralizer holder onto wall.
Note: Avoid over tightening
screws. Drilling holes into solid
surfaces or surfaces made of
stone should only be performed
by a certified installer.
COLD
3. Measure white tubing
attached to faucet to
outlet of remineralizer
and cut to desired length.
Note: Save leftover tubing
for a future step.
⁄ " of each screw
3
8