Powering Up Your Faucet
Once batteries are inserted or AC power is supplied, the faucet will begin
start-up mode. The blue LED indicator light on the Ready Sensor will blink,
water will run for ten (10) seconds, then the blue light will blink again.
Do not stand directly in front of faucet during startup/calibration.
Adjusting Hands-Free Temperature
When you use your faucet in the hands-free mode, MotionSense supplies water
at a preset mid-mix temperature. To adjust temperature, simply use the dial on
the under-counter control box to adjust to your desired preset temperature mix.
Cleaning Mode/Guest Mode
Disable or enable
both sensors
with one simple
motion.
Disable or enable
the Ready Sensor
with two simple
4
motions.
Watch MotionSense deliver convenience on command.
Scan here for a video demo.
(First, download the app at getscanlife.com.)
Disabling MotionSense Hands-Free may be helpful when
you are cleaning your faucet or when guests unfamiliar with
MotionSense will be using your kitchen.
To Disable Both Sensors
Hold your hand directly above the Wave Sensor for approximately
five (5) seconds. Water will begin to run and then turn off,
indicating MotionSense Hands-Free has been disabled.
To Enable Both Sensors
Simply repeat the process, holding your hand above the Wave
Sensor for five (5) seconds until water begins to run again.
To Disable the Ready Sensor Only
Using the handle, turn the faucet on and then hold your hand
above the Wave Sensor for approximately five (5) seconds.
To Enable the Ready Sensor Only
Simply repeat the process. Using the handle, turn the faucet on
and then hold your hand above the Wave Sensor for approximately
five (5) seconds until water begins to run again.
Easy under-
counter water
temperature
adjustment