Installation - Glacier bay FS6AC071CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Remove the lock nuts (G), metal washer (D) and
rubber washer (C) from the faucet.
□
WITHOUT DECK PLATE: Insert the supply lines (H)
through the mounting hole in the sink until the
faucet (A) sets on top of the sink.
□
WITH DECK PLATE: Align the hole in the gasket (G)
and deck plate (F) with the mounting hole in the
sink. Insert the supply lines (H) through the deck
plate (F) and mounting hole in the sink until the
faucet (A) sets on top of the deck plate (F).
NOTE: If the sink is uneven, use silicone under the
F
gasket (G).
G
1
F
G
1
A
H
A
H
A
H
2
A
H
2
4
2
Preparing the pop-up assembly
□
Insert the drain assembly (I) and rubber washer
(J) into the sink.
□
Secure the drain assembly (I) in place under the
sink using the large rubber washer (K) and lock
nut (L).
1
2
K
L
I
J
3