Saeco Nina plus Instrucciones De Uso página 17

correctly placed under the coffee dispensing holes.
(Fig.14) - Turn the selection knob (17) to the "
position.
turn the selection knob (17) to the "
to stop coffee brewing. Wait a few second after brewing
has stopped, then remove the cups of coffee (Fig. 15).
(Fig.16)
the remaining coffee residues.
clean to guarantee perfect results. Clean daily
after use.
(Fig.10)
(Fig.7A) - Insert the coffee pod adapter (13) - with the
(10).
(Fig.7B) - Then, insert the pod filter (14) into the
(Fig.11)
unit (6) from the bottom.
(Fig.12)
locks into place. Release the grip from the pressurized
leftwards.
(Fig. 14)
the selection knob (17) to the "
coffee brewing.
knob (17) to the " " position in order to stop hot water
dispensing.
(Fig.16)
machine by turning it from right to left. Be careful not to
(Fig.9B)
(Fig.11)
bottom (6).
(Fig.12)
in place.
1 preheated cup
make sure that it is correctly placed under the coffee
dispensing holes.
(Fig.14) - Turn the selection knob (17) to the "
position.
turn the selection knob (17) to the "
to stop coffee brewing, then remove the coffee cup.
(Fig.16) - Wait a few seconds after brewing, then remove
"
" position in order
results. Clean daily after use.
As a general rule any type of coffee available on the
market can be used. However, coffee is a natural product
it is therefore a good idea to try different types of coffee
For optimal results, however, we recommend using
espresso machine blends. As a rule, Coffee should
by using a different coffee grind.
Saeco recommends using single-dose coffee pods
marked ESE for a tasty coffee and easier cleaning and
preparing.
" position until some
(Fig.3) - Press the ON/OFF button (2).
machine is now ready.
(Fig.18) - Place a container or a teacup under the steam
spout (Pannarello).
(Fig.5) - Open the knob (4).
(Fig.6) - Switch the selection knob to the "
(17).
dispensed, set the selection knob (17) to the "
position.
(Fig.5) - Close the knob (4).
"
" position in order
(13) should be kept clean to guarantee perfect
" position
"