Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(1)
Monitor.
(4)
Handlebar tube.
(9L) Top focus bar, left.
(9R) Top focus bar, right.
(19) Main post.
(16L) Bottom left focus bar.
(16R) Bottom right focus bar.
(36L) Pedal left foot.
(36R) Pedal right foot.
(37L) Left footrest.
(37R) Right footrest.
(63) Rear
stabiliser
adjustable feet.
(82) Main body.
(83) Front stabiliser bar with wheels.
Fig.2 NUTS & BOLTS
(10) Flat washer 8x30x2.
(13) Screws M-8x20.
(14) Spring washer M-8.
(20) Screws M-10x70.
(23) Flat washer M-10.
(24) Self-locking nuts M-10.
(61) Corrugated washer M-8.
(64) Screw DIN 603 M-8x75.
(65) Self-locking nuts M8.
(79) Screws M-8x15.
(80) Flat washer M-8.
(87) Screws M-8x20.
(102) Box spanner.
(103) Box spanner.
(104) Allen key 5 mm
2.- FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (83) to the main body (82)
positioning the wheels at the front of
the unit, Fig.3, insert screws (64), fit
the
corrugated washers (61) and self
locking nuts (60), and tighten securely.
Take the rear stabiliser bar with
adjustable feet (63), Fig.4, insert the
bolts (64); fit the spring washers (14),
the corrugated washers (61) and self
locking nuts (60), and tighten securely.
3.- FITTING THE MAIN POST.-
Remove the screws (79) and washers
(14) and (61) from the bottom of the
main post (19).
Bring the main post (19) up to boss on
the main body (82), Fig.5.
Take the tip of the tension cable (88),
sticking out of the bottom of the main
post (19) and connect it to the tension
bar
with
support (26), as shown in Fig.5A.
Plug connector (91), coming out of the
main post (19), into connector (81),
coming out of the boss on the main
body (82), Fig.5A.
Slip the main post (19) over the boss
(82) on the main body in the direction
of the arrow, Fig.5, making sure not to
snag any of the cables.
ATTENTION: Make sure that the
tension control (88) Fig.5, functions
correctly by turning it clockwise and
anticlockwise.
Fit the screws (79), along with the
washers (14) and (61), removed
previously, Fig.5, and tighten securely.
When
assembled,
tension control (88) works correctly.
4.- FITTING THE BOTTOM
FOCUS BARS.-
Loosen screw (13) on the shaft of the
main post (19), Fig.6A, along with the
spring washer (14) and the flat washer
(10).
15
spring
washers
the
machine
make
(14),
the
has
been
sure
that
the
Publicidad
