Publicidad
Idiomas disponibles
Idiomas disponibles
Fit the bottom right focus bar (16R)
onto the shaft on the main post (19),
Fig.6B.
Refit screw (13) along with the spring
washer (14) and flat washer (61),
removed previously, into the shaft on
the main post (19), Fig.6 and tighten
securely.
Loosen screw (13) on the shaft of the
main post (19), Fig.6A, along with the
spring washer (14) and the flat washer
(10).
Fit the bottom left focus bar (16L) onto
the shaft on the main post (19),
Fig.6B.
Refit screw (13) along with the spring
washer (14) and flat washer (61),
removed previously, into the shaft on
the main post (19), Fig.6 and tighten
securely.
5.- FITTING THE FEET.-
Follow the installation instructions
for the foot pedals carefully, as
incorrect installation could damage
the thread on the foot pedal or the
crank.
The right and left position described in
this
paragraph
assembly procedures refer to the
position that the user adopts when
using the machine to do exercise.
Take the left foot pedal (36L), (marked
with the letter L), and release nut
(46L). Screw the shaft onto the left-
hand crank (45L), also marked with an
(L), Fig.7A, in a clockwise direction.
Tighten securely, Fig.7A.
Next,
refit
nut
previously, and tighten securely.
Take the right foot pedal (36R),
(marked with the letter R), and release
nut (46R). Screw the shaft onto the
right-hand crank (45R), also marked
and
remaining
(46L),
removed
with an (R), Fig.7B, in an anti-
clockwise direction. Tighten securely,
Fig.7B.
Next,
refit
previously, and tighten securely.
6.- ATTACHING THE FOCUS
BARS TO THE FOOT BARS.-
Take the right foot bar (36R) and
position it on the "U" at the bottom of
the right focus bar (16R), Fig.7C.
Insert screw (20), as shown in Fig.7C,
then fit the flat washer (23) and the
self locking nut (24), and tighten
securely.
Take the left foot bar (36L) and go
through the same assembly procedure
as with the right foot.
7.- FITTING THE FOOTRESTS.-
Next, remove the knobs (49), the flat
washers (47) and the screws (38) and
position the left footrest (37L) (marked
with the letter "L") on top of the unit's
left foot (36L), Fig.8, (left and right
refers to the user's position doing
exercise) refit the screws (38), the
washers (47) and the knobs (49)
removed
previously
securely.
Next, position the right footrest (47R)
(marked with the letter "R") on top of
the right foot (36R), refit the screws
(38), the washers (47) and the knobs
(49) removed previously and tighten
securely.
8.- FITTING THE HANDLEBAR.-
Take
the
screws (13), position the ends of the
handlebar on the plate at the top of
the main post (19), Fig.9. Refit the
screws (13) removed previously.
16
nut
(46R),
and
handlebar
(4),
removed
tighten
remove
Publicidad
