McCulloch MCS2003 Manual Del Usuario página 4

2 - SAFETY PRECAUTIONS
15. The operation of any tool can result in foreign
objects being thrown into your eyes, which can
result in severe eye damage. Before operating power
tool, always wear safety goggles or safety glasses with
side shields and a full face shield when needed. We rec-
ommend wide Vision Safety Mask for use over eye-
glasses or standard safety glasses with side shields.
2-3. EXPLANATION OF NOTE, WARNING,
AND WARRANTY SYMBOL
1. A NOTE is used to convey additional information, or
highlight a particular explanation, or to expand a
instruction.
A WARNING identifies a procedure which, if not
2.
undertaken or if improperly done, can result in a seri-
ous personal injury or damage to the unit and/or both.
3. (WARRANTY SYMBOL) serves notice that
unless instructions or procedures are followed,
any damage will void the warranty and repairs will be
at owner's expense. Service other than user mainte-
nance should be performed by a McCulloch
Authorized Service Center. Damage or conditions
caused BY improper maintenance practices which
render this product inoperable will void the manufac-
turer's warranty.
4. FOR WARRANTY OR SERVICE contact the nearest
McCulloch Authorized Service Center.
Use of these personal safety items is
highly recommended to reduce the risk
of accidental injury.
Never place hands into ejection
chute as serious injury will
occur.
2-1
2-4. INTERNATIONAL SYMBOLS
1. Never place hands into discharge chute as serious
injury will occur (Figure 2-1).
2. Use of these personal safety items is highly recom-
mended to reduce the risk of accidental injury (Figure
2-2).
SAVE THESE
INSTRUCTIONS
2-2
6
3 - ASSEMBLY INSTRUCTIONS
3-1. CONNECTING WHEEL ASSEMBLY
1. Place legs onto axle. Put the wheel spacers and
wheels onto the ends of the axle.
2. Secure wheels using the flat wheel washers and
wheel nuts.
3. Put on wheel caps.
3-1A
3-2. LEGS ASSEMBLY
1. Open the hopper chute by turning the caging knob,
then place the motor housing on a flat surface.
2. Secure legs using the four bolts, saddle washers and
nuts. (2 per side)
3-2A
3-3. HOPPER ASSEMBLY
Place the hopper on top of the feed tube and align the fix-
ing holes. Secure with the safety set screws.
3-3A
7