2 Installation
Up to four I/O Modules can be connected to each controller.
Installation schematic
1 If the AC MON (Mains Present) or the Tamper inputs are unused they should be connected to 0V/GND.
2 A/B/0V RS485 wiring total length 1.4km/0.87miles.
2.1 Setting I/O Module address
I/O Module is set using the DIP switches:
I/O Module Addr 1:
Switch 8 ON
I/O Module Addr 2:
Switch 7 ON
© Vanderbilt 2018
EN – 6
A-100442
01.02.2018