Operation; Checking For Leaks - Glacier bay FP2BC420CP Guía De Instalación Y Cuidado

Operation

1

Checking for leaks

□
Ensure the handle is in the off position. Turn the
hot and cold water supplies on and check all
connections for leaks. If leaks are discovered,
check the connections to ensure they are tight
and properly secured.
□
Detach the pull-out spray head (B) from the
spray hose (L). Hold the spray hose (L) firm to
prevent it from retracting into the faucet body
(A).
□
Lift the handle to allow the water to run for
approximately one minute. This flushes away
any debris that could damage the internal parts.
□
If the flow rate is low, please check for debris at
the check valve in the hose adapter.
□
Turn the water off and reattach the pull-out
spray head (B) and pull-out spray hose (L).
2
Removing the quick connector
CAUTION: Be careful when removing the quick
connector hose to prevent cutting your hands.
□
If it is necessary to remove the
quick connector (M), push the quick
connector housing up, hold the housing
together and pull down.
B
L
1
7
Please contact 1-855-HD-GLACIER for further assistance.
A
B
L
Check valves
Quick connector
2
3
HOMEDEPOT.COM/GLACIERBAY
A