Allen + Roth LWS60DVAG Manual Del Usuario página 3

ASSEMBLY INSTRUCTIONS
Vanity Feet Installation
4. Insert wood dowel (EE) into front feet (D) and back feet (E). Attach
front feet (D) and back feet (E) to the vanity base (B) by inserting the
bolts (BB) through lock washers (CC) and flat washers (DD). Tighten
with hex wrench (FF).
Attach suppot leg (F) to bottom of vanity base (B) and screw the
pre-assembled bolt into place.
Hardware Used
BB
Bolt
CC
Lock Washer
DD
Flat Washer
EE
Wood Dowel
FF
Hex Wrench
Adjustable Level
5. In case of uneven floors, floor levelers are provided at the bottom of
the vanity. If necessary, adjust floor levelers by hand to correct tilting
and/or level doors.
Backsplash Installation
6. To mount the backsplash (C) to the wall, apply a thin bead of silicone
compound (not included) to the unpolished back side and bottom of the
backsplash (C). Position backsplash (C) as shown onto vanity top (A)
and against the wall. Clean any excess silicone compound before
allowing to dry.
4
EE
D
B
D
x 8
F
E
x 8
x 8
5
x 8
x 1
6
C
A
4
ASSEMBLY INSTRUCTIONS
Hinge Adjustment For Door Alignment
7. If the doors preassembled to vanity base (B) require adjustment, follow
the below options as needed:
E
To adjust door up or down, loosen screws (a), adjust door and retight-
en screws.
DD
CC
To adjust door left and right, turn screw (b) in or out.
To adjust door in and out, loosen screw (c), adjust door and retighten
screw.
DD
CC
BB
Removing the Drawer:
8. Unload the contents from the drawer.
Slide out the drawer as far as it will go.
Press the lever down on the right-hand track and lift the lever up on
the left track to release the drawer. Pull the drawer out the rest of the
way.
Replacing the Drawer:
Align the drawer guides with the receiving glides.
Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time after it
has been removed.
Push the drawer in completely.
Silicone
7
B
8
5