Publicidad
Idiomas disponibles
Idiomas disponibles
17
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide
improved vibration resistance, reduced maintenance and faster
installation.
• Refer to wiring diagram,
step 18A, 18B, or 18C.
• Push screwdriver FIRMLY
into square hole.
• Insert wire into round hole.
• Use green terminal for braid
and ground wires.
THERMAL MANAGEMENT SOLUTIONS
• Remove screwdriver.
• Repeat for all connections.
EN-RaychemJBM100A100A6-IM-H56344 03/13
To connect wires, firmly insert a slotted screwdriver into the
square hole (
) to open the spring. When fully inserted, the
1
2
screwdriver will lock into place, allowing you to remove your
hand and insert the wire into the round hole (
screwdriver to clamp the wire. The wire is held securely against
the bus bar for low contact resistance over time without the need
to periodically retighten screws.
2
Wire
). Remove the
1
2
1
Screwdriver slot
Wire hole
7 / 10
Publicidad
