Important Safety Instructions - Aquatlantis AQUARIUM Manual De Instrucciones

with water carefully so that the sand doesn't
06
move. We advise you to put a container on the
sand and let the water run on it. Before you place
the fish, let the water of your aquarium stabilize
EN
(temperature, pH, etc.) so that the health and
well-being of your fish can be assured.
EQUIPMENT AND MAINTENANCE
Tecatlantis filter
If your aquarium is equipped with a Tecatlantis
filtration system, read and follow the instructions
included in it.
LED Lighting System
Due to its performance under low voltage, the LED
lighting system is much more secure, economic and
has a longer life in comparison to the traditional
lighting systems. The emitted light has an excellent
quality, being the ideal for the well grown of the
aquatic species.
The LED lighting system does not need
maintenance. In case of failure or damage on the
power cord or malfunction of the system, these
cannot be repaired. You should replace it by a new
one.
OR
LED H2O Lighting System
The LED H2O light units allow the circulation of
the water inside the system, providing their
cooling. This way, the LED H2O lighting system
has a longer lifetime. Due to its performance
under low voltage, it is safer and economical. In
case of breakdown or damage with the power
cable or the system itself, there is no possibility
of reparation. The whole system must be
replaced by another. Only the water pump is
replaceable in the system.
Pump maintenance -
the system, follow the following steps and
consult the illustrations in the end of this guide.
1. Unscrew the screws and remove the piece A.
2.
Press the piece C and, simultaneously, undock
the piece B.
3.a)
Remove the foams D.
b) Slide the piece C through the light unit
aluminium rail.
c) Undock the EasyFlux pump E from the tube.
To proceed to the cleaning of the pump, consult
its guide.
Cleansing -
Every time the maintenance is made,
proceed with the cleaning of the H2O lighting
system, introducing a water jet through the
interior of the circuit.
All manuals and user guides at all-guides.com
To undock the pump from
DISPOSAL:
Do not dispose the product as
common garbage. It should be delivered in
an adequate recycling center.

IMPORTANT SAFETY INSTRUCTIONS

To guard against injury, you should take
Warning!
some precautions when handling the light unit,
including the following:
READ AND FOLLOW ALL THE SAFETY
1.
INSTRUCTIONS for
understanding of this product. Failure to do so
may result in damage to it.
a) Do not operate any appliance if it has a damage
cord or plug, or if it is malfunctioning or damage
in any manner.
b) To avoid the possibility of the appliance plug or
receptacle getting wet, put the unit to one side of
a wall mounted receptacle to prevent water from
dripping onto the receptacle or plug. A "drip loop"
(see illustration) should be arranged to the
receptacle. The "drip loop" is the part of the cord
below the level of the receptacle or the connector
if an extension cord is used, to prevent water
travelling along the cord and coming into contact
with the receptacle. If the plug or receptacle does
get wet, DON´T unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the
appliance. Then unplug and examine for
presence of water in the receptacle.
2. Close supervision is necessary when any
appliance is used by or near children.
3. To avoid injury, do not contact moving parts or
hot parts, such as heaters.
4. Always unplug the appliance from the outlet
when not in use, before putting or taking off
parts, and before cleaning. Never yank the cord to
pull the plug from the outlet. Grasp the plug and
pull it to disconnect.
5. Do not use an appliance for other than the
intended use (i.e. don't use on swimming pools,
garden ponds, bathrooms, etc.). The use of
non-recommended attachments may cause an
unsafe condition.
6. Do not install or store the appliance where it
will be exposed to the water or to temperatures
below freezing.
7. Make sure that the appliance is securely
installed before operating it.
Do not plug the light unit if there is
WARNING:
water on parts not intended to be wet. Do not
place any objects on the light unit. Ensure
sufficient air space around the same.
8. Read and observe all the important notices on
the good use and